FLEXOTERM 20MMx120CM CUT TO MEASURE High thermal insulation panel

Description

FLEXOTERM 20MMx120CM CUT TO MEASURE
High density modified polyethylene panel (28 kg/m³) and high thermal insulation (U = 0.04 W/m²K)
20 mm thickness
Examples of purchasing products cut to size:
by purchasing quantity 1 you will receive a piece of panel along one linear meter
by purchasing quantity 2 you will receive a piece of panel along two linear meters
by purchasing quantity 3 you will receive a panel piece three linear meters long
by purchasing quantity 4 you will receive a panel piece four linear meters long
by purchasing quantity 5 you will receive a panel piece five linear meters long
by purchasing quantity 6 you will receive a piece of panel long six linear meters
by purchasing quantity 7 you will receive a piece of panel long seven linear meters
by purchasing quantity 8 you will receive a piece of panel long eight linear meters
by purchasing quantity 9 you will receive a piece of panel long nine linear meters
by purchasing quantity 10 you will receive a piece of panel along ten linear meters
so on up to a maximum length of 15 linear meters which corresponds to the length of a whole Flexot roll erm 20 mm.
Description:
the Flexoterm insulating panel has been specifically designed for the redevelopment of old roller shutter boxes and represents the main component of the PosaClima renova system. It guarantees a self-supporting elastic structure and is very easy to work with. It can be cut with scissors or a cutter and is perfectly impermeable to steam and air. The reflective surface made with a special aluminized film (thickness 30 my) reflects infrared radiation inwards, greatly improving the already high insulating performance of the panel. Available in two thicknesses: 10 and 20 mm, packaged in rolls of 25 and 15 meters respectively. The insulating power increases as the thickness increases and it is therefore always preferable to use the 20 mm version, unless there are housing problems inside the box compartment.
Fields of application:
the Flexoterm panel is a component of the Posaclima Renova system specifically designed for the insulation of old wooden, sheet metal or masonry bins. It can be used both in front inspection bins (where it is always combined with the Termopav panel in the lower part of the box), and in lower inspection bins. It can be installed inside the box compartment in a very simple way: after having completely unrolled the roller shutter and having taken the width and depth measurements, the panel is cut to size and inserted first into the upper containment bar previously fixed to the wall , and then in the lower bar. The shutter is then rewound to check that it is completely rewound without impediments caused by its insertion into the Flexoterm box compartment. Remember that before this operation the sides of the box compartment must always be isolated by cutting the Flexoterm panel to size and inserting it in contact with the sides (taking care to cut the panel so that it can be housed in the presence of the winding shaft). It is possible to fix the panel even without the containment bars: in this case we proceed by sealing it to the box compartment with Hanno Elastoschaum polyurethane foam. Warning: using the foam, the panel can only be removed by cutting the hardened foam with a cutter. However, it is possible to re-seal it simply by applying another bead of foam between the panel and the box compartment.
Brand:
PosaClima
Manufacturer code:
KLRFLEXO2015
Andromedagie code:
RNV00003A
Upgrading the energy efficiency of the window hole without masonry (IT)
Manuals - The thermo-acoustic insulation of the box (IT)
Data sheet - Flexoterm (IT-EN)
Comment Feedback